Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

The OTA CCDs have known artifacts and anomalies. A lot of work has gone into characterizing these artifacts, and removing them if possible. Pixels affected by these artifacts or anomalies are kept tracked of in the mask images with pixel flags.

 

Tip
iconfalse
titleContents

Table of Contents
maxLevel2
indent20px

Row-by-row bias correction

Certain CCDs suffer from an issue whereby the bias level varies between rows. A software fix based on a linear fit to the bias in each row (check if this is correct?) has been applied on CCDs prone to this effect, however

  • sometimes CCDs are not identified as problematic so this issue is not corrected.
  • in areas of strongly varying background (such as large galaxies) the fix itself can introduce extra problems as the bias level cannot be correctly estimated.

     

    Image AddedExample of row-by-row bias artifact on a g-band warp.
    Image ModifiedExample of problems on a warp caused around a bright galaxy by the row-by-row bias correction.
    Image ModifiedAn example of uncorrected row-by-row bias effects imprinting through onto a stack.

Background oversubtraction

The sky subtraction routine is known to over-subtract around large galaxies or areas of nebulosity. There is currently no fix for this.

Burntool artifacts

Amplifier glow

Amplifier glow can sometimes be seen at the corners of the CCDs. These areas are usually masked, but in some cases the mask is either too small or not present.

Astrometry failures

On some stacks, if one or more input warps has poor astrometry this can imprint through to the stack (in particular, supposedly masked areas such as the centres of bright stars can show a background star field poking through). This is quite rare and mostly seen in crowded fields.

 

Align
alignleft